Description Of The Audio Kit; Description Of The Installation Brackets - Midland BT2 Handbuch

Description of the audio kit

The audio system includes two ultra-flat stereo speakers and
two interchangeable microphones, which are both supplied
with a bracket and wire connection.
Fixing the stereo speakers. The two stereo speakers have
a Velcro/adhesive strip that aids their fixing to your helmet.
Beware to not completely cover your ear with the speak-
ers, you must always be able to listen to the traffic sound
and indication.
The microphone can be fixed onto the helmet in two ways:
Boom Microphone. Place the section with the Velcro/ad-
hesive strip between the padding and the rigid cover of the
helmet, so that the microphone is correctly positioned in front
of your mouth and that the white symbol is facing your mouth.
This type of microphone is suited for Open Faced and Flip
Front helmets.
Wire microphone. Using the Velcro/adhesive strip, place the
microphone inside the helmet in front of your mouth. This type
of microphone is more suited for Full Faced helmets.
The mini connector on the microphone allows you choose the
microphone that best suits the helmet you are using.
The audio kit must then be connected to the central jack of
the Midland BT2 Intercom unit using the "L" shaped connec-
tor. This connector is very flexible and can be easily adapted
to most commercial helmets.

Description of the installation brackets

The Midland BT2 can be fixed onto the helmet in two different
ways: By either using the plate with bi-adhesive strip, or the clamp.
These methods allow you to safely "fix" the BT2 unit onto your hel-
met and to remove it at any time in order to recharge or store it.
Plate with bi-adhesive strip
The fixing plate has a bi-adhesive strip on one of its sides. To
fix the plate in place, clean the application area on the hel-
met surface, remove the bi-adhesive film and place the fixing
plate on the helmet by keeping it contact with the surface for
a few seconds.
Clamp
Using the Allen Key, loosen
the two screws on the clamp
and place the rear plate be-
tween the helmet padding
and the external rigid protec-
tion. Then, tighten the two
screws in order to firmly fix
the clamp in place.
Fitting and removing your Midland BT2
The BT2 can be easily fitted onto the helmet by sliding it
downwards so that it fits into the slot of the selected fixing
device (plate with bi-adhesive strip or clamp).
BT2 is maintained in position thanks to the fixing clip located
on the upper section (A).
To detach the BT2, simply press the fixing clip and push the
unit upwards.
A
5