Maintenance; Technical Data; Declaration Of Conformity - Conrad Visiondrive Bedienungsanleitung

Running the cables
All cables leading to the motor vehicle camera must be securely fastened on the windshield
with cable fasteners. To obstruct the view as little as possible, it should run along the edge.
Please refer to the instructions in the manual for the main unit Order No. 840462.

Maintenance

Check the lens of the camera occasionally, clean it of dust and dirt. Use an appropriate lens
cleaning system, e. g. a clean, soft brush. Do not press too hard on the optics/mechanics of
the camera, since it may be damaged. Furthermore, you may cause scratch marks on the lens.
Disposal
Electronic devices are recyclable waste materials and must not be disposed of in the
household waste!
Please dispose of the product, when it is no longer of use, according to the current
statutory requirements.
Remove any inserted battery and dispose of it separately from the product.

Technical Data

Power supply .............................................. from main unit Order No. 840462
Voltage needed 12V .................................... approx. 100 mA
Camera Resolution ...................................... 640 x 480 (VGA), 30 frames per second
Light sensitivity ............................................ from 0.1 Lux
IR-LEDs ....................................................... 2
Camera detection angle horizontally ........... max. 156°
Camera detection angle vertically ............... max. 65°
Permitted operating temperature ................. -20°C to +60°C
Weight ......................................................... approx. 40g
Dimensions (W x H x D) .............................. 52 x 32 x 28 mm
Camera cable length ................................... approx. 40 cm
Extension cable length ................................ approx. 380 cm

Declaration of Conformity

The manufacturer hereby declares that this product conforms to the fundamental requirements
and the other relevant regulations of Directive 1999/5/EC.
☞
The Declaration of Conformity for this product can be found at www.conrad.com.
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfi lming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2012 by Conrad Electronic SE.