LG VR64701LVMP Bedienungsanleitung Seite 29

SMART DIAGNOSIS
If a voice message is announced after Smart Diagnosis, refer to the following table to take proper actions.
Voice message
Robot Cleaner smart diagnosis will be started. Please step
away and clear around 1 meter around the home station.
Smart diagnosis can start when it is being charged. Please
dock Robot Cleaner to the home station to charge.
No defect found during diagnosis.
Diagnosis mode cannot be operated due to a low battery.
Please try again after the battery is charged.
Please check if the dust bin is installed with the filter.
Charging cannot be done due to a problem in infrared sensor.
Charging cannot be done due to a problem in ultrasonic
sensor.
Charging cannot be done due to a problem in the cliff
detection sensors on the bottom. Please clean the sensors.
Please wipe the lower camera sensor on the right bottom of
the Robot Cleaner.
Please wipe the obstacle detecting sensor window on the left
and right side of the Robot Cleaner.
A problem has been found on the Gyro Sensor.
Please check for dirt on the left wheel.
Please check for dirt on the right wheel.
A problem has been found on the left wheel sensor.
A problem has been found on the right wheel sensor.
Please check the brushes for obstructions.
A problem has been found in the suction motor.
A problem has been found in the acceleration sensor.
In order to listen to the smart diagnosis result again, please
press the charging button. To stop, please press the stop
button.
Smart diagnosis mode will be turned off.
Please try smart diagnosis again after turning the main power
switch off and on from the back of Robot Cleaner. If the
problem continues, please contact LG Electronics customer
care.
Smart Diagnosis mode cannot be operated with mop plate
being attached. Please try again after removing it.
Smart diagnosis has failed to operate. Please try it again after
turning off and on the main power switch on the back of the
Robot Cleaner.
28
Measures (for reference)
Clear any object within a 1 m radius around Home Station,
and stay back until the diagnosis is complete.
Move Robot cleaner to the Home Station to recharge it.
Try the Smart Diagnosis again after recharging the battery.
Open the Dust Bin Cover and examine the bin.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
Clean the three Cliff Sensors on the bottom at the front of
the unit.
Clean the lens of Camera Sensor on the bottom-right.
Clean the lens of the Obstacle Sensors on both the left and
right hand sides.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
Check for foreign materials on the left wheel.
Check for foreign materials on the right wheel.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
Check for any foreign material stuck in the Brush.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
If you need to repeat the diagnosis result, press the 'Home'
button, or press 'Stop/OK' button to finish the diagnosis.
Run Smart Diagnosis again after removing the Mop Plate.
Turn the main power switch OFF and then ON again to
resume the diagnosis. Do NOT touch the robot or disturb
its operation until the diagnosis is complete.