Electrical Supply; Using The Computer - Crivit ER-1512 Bedienungsanleitung

Adjust handlebar
The handlebar tilt can be adjusted using the handlebar clamping screw.
The handlebar is designed to allow for various gripping positions.
Alternate your grip during training! This prevents uneven strain.
Be sure the teeth of the handlebar clamp interlock with the teeth
of the handlebar. When turning the handlebar you will feel the teeth
interlocking – tighten the handlebar screw very tightly!
Before any training verify the screw is tight and carefully check the
handlebar is tight.
9c

Electrical supply

The mains cable is already built into the equipment. Unwind the mains
cable at the back of the equipment (Fig. 10a).
Please note the stop mark on the cable. Do not unwind the cable
beyond the stop mark. Insert the power plug into the socket.
10a
Please note: only use equipment in dry rooms, connected to an
appropriate and properly installed 230V/50Hz isolated ground
receptacle. The equipment can now be switched on and off with the
main switch (Fig. 10b).
10b
The article has an automatic cable rewind. As soon as you press the
button on the lower right enclosure the cable will rewind (Fig. 10c).
10c

Using the computer

Once the ergometer is switched on but the pedals are not being
used the message "Please disconnect equipment from mains" will ap-
pear. As soon as you make entries or begin exercising by pedalling the
message will disappear.
11
GB/IE 15