Connection - Velleman 8020 Bedienungsanleitung

Connection

CONNECTION
Connect the amplifier inputs to the different sources. Use good quality audio
leads. Respect the Left and Right channels. Connect the output to a suitable ste-
reo power amplifier or two mono amplifiers (e.g. our 4020, 4040, or 2x 8010) .
Connect the power-cord to the mains connector. Check for correct mains volt-
age. Normally the standby/mute LED at the front will be lit (*1).
1. Auxiliary input. Connect any line level (*2) unit to this input.
2. CD input. Connect you CD player or other line level (*2) unit to this input.
3. Tuner input. Use this input to connect your tuner, or other normal line
level (*2) unit.
Aux
CD
L
IN
R
(*1) At first time power up, or after a mains voltage failure, the +6dB LED will lit
together with the standby/mute LED.
(*2) Line level is a source with voltages between 150mV and 2V.
6
4. Audio/Video audio input. Use this input to connect your audio
signal coming from a VCR, DVD, MD, CDR player/recorder...
5. Monitor output, can be used to connect to the audio
record input of your tape, VCR, MD, CDR... recorder.
8020 Valve Control Amplifier
Tuner AV Monitor
CAUTION
Risk of electric shock
Disconnect mains before opening
6. Line output. Connect to your power amplifier.
AC POWER
Line
L
OUT
R
MAX 16VA
!
7. Mains connector
and fuse holder,
replace only with
indicated ratings!
8. Mains volt-
age indica-
FUSE
250mA
Check
voltage
setting
115VAC
230VAC