Operation - Velleman 8020 Bedienungsanleitung

OPERATION

CAUTION: Before turning on the power amplifier(s) turn down the volume
control.
1. Standby/mute button and indication. Press this button to turn on the unit or to mute
the sound. Keep this button pressed to set the unit in standby.
After power on, it will take about 30 seconds (warm up) before the muting will be off.
The muting button is disabled during this time!
2. Monitor indication. See point 4 for use.
3. +6dB indication. See below for use.
4. Input selection buttons and indication.
8020
Valve Control Amplifier
+6dB
Monitor
F
The +6dB function can be used to adjust the level between the different
sources. That way, when switching over between sources the volume will
approximately remain the same.
(*) When the power-cord is disconnected or after a power failure the memory will be erased.
Turning on the unit with the input selection buttons will activate a 24h auto standby timer.
Press once to select the input.
Press a second time to turn on the monitor output.
Press and hold the input selection button a second time to turn on
the +6dB function for this input. The +6dB will be memorized (*)
each time the corresponding input is selected.
Selecting an input will also turn on the unit.
NOTE: During switchover between input, the sound will be muted
for about 3 seconds.
AV
Aux CD Tuner
Operation
5. Volume control.
7