Connection - Velleman 8040 Bedienungsanleitung

CONNECTION

Place the amplifier in a well ventilated area. Never operate the amplifier inside
a non ventilated area. Connect the amplifier input to the output of an appropriate
pre-amplifier or control amplifier (e.g. our 4100, 8020, 8021). Use good quality audio
leads. Respect the Left and Right channels in a stereo configuration. Connect the
power-cord to the AC power connector. Check for correct mains voltage.
F
The nominal input signal is 0.775V (0dB) for maximum output.
Turn off the Power before
making any connection !
1. Mains power switch. Use this switch
if the unit is not used for a longer
period.
2. AC Power indication.
3. AC Power and fuse holder, replace
fuse only with indicated ratings!
4. Speaker output connectors, use
good quality speaker wires of 4mm
or higher. Respect the speakers
polarity.
5. Signal input connector. Use good
quality cords for connection with
pre- or control amplifier.
6. Signal bypass output. Use this
output if separate amplifiers and
speakers are used for low and high
frequencies.
See setup examples pages
2 and 3
Connection
7