Sygonix 595688 Bedienungsanleitung Seite 29

• Guide the connection cable either from the side of the mounting ring
or push it through a present hole in the wall or ceiling where you have
attached the mounting ring.
Protect the plugs from dust and dirt, e.g. with a small plastic bag.
If the connection cable is too short (depending on assembly position), use a
suitable connection box that must be installed near the camera.
This connection box must be suitable for assembly in the outdoor area depen-
ding on assembly site of the camera.
The cable connection for the video
output or the power supply can be
placed in the connection box; this
also applies to the housing with
the operating button in the camera
cable, see fi gure on the right.
Place the cables so that they are protected from manipulation, e.g. in a
cable duct or similar.
• Place the camera on the mounting ring. Ensure that the cable is not crushed.
• Fasten the camera to the mounting ring by turning in the three grub screws
that were loosened fi rst.
29