Braun BN0095 Gebrauchsanweisung Seite 6

Adjusting the chronograph: hands to zero position
This procedure should be performed when one or several
chronograph hands are not in their corret zero positions
and have to be adjusted (e.g. following a battery change).
1. Pull out the crown to position II (all three chronograph
hands are in their correct or incorrect zero position).
2. Keep push buttons A and B depressed simultaneously
for at least 2 seconds (the centre stop-second
rotates by 360°  corrective mode is activated).
Adjusting the chronograph second hand
Single step: press button A 1 x short.
Continuous: press button A long.
Adjusting the next hand: press button B.
Adjusting the hour counter (position 6h)
Single step: press button A 1 x short.
Continuous: press button A long.
Adjusting the next hand: press button B.
Adjusting the minute counter (position 9h)
Single step: press button A 1 x short.
Continuous: press button A long.
Returning the crown to normal position
Termination of the chronograph hands
adjustment (can be carried out at any time).
Guarantee
2 year guarantee against material and workmanship defects. The
guarantee is valid in those countries where the watch is officially being
sold.
The warranty is conditional to presentation of an evidence of the date
of purchase, such as the original, correctly filled-in warranty card or the
dealers' invoice. The service technician appointed by the manufacturer
or its official distributor will be the final judge in determining, whether
the cause of defect is within the manufacturers responsibility.
Excluded from this guarantee: batteries, crystals, wear and tear,
damage caused by misuse, accidents or neglect.
Warning! Do not dispose of empty batteries in the household waste.
Take them to special local collection site.
6