Replacing The Stamp Cartridge (For The Color Image Reader Unit-H1) - Canon 4251i Anwenderhandbuch

Replacing the Stamp Cartridge (For the Color Image
Reader Unit-H1)
Originals sent via the feeder can be stamped to indicate
that they have been sent. Replace the stamp cartridge
when the stamp mark is faint or no longer visible.
IMPORTANT
When replacing the stamp cartridge, take care not
to allow ink to come into contact with your hands or
clothing. If ink gets onto your hands or clothing, wash it
off immediately with cold water.
NOTE
The Color Image Reader Unit-H1 is an optional product.
1
Open the covers.
1. Pull the lever → open the feeder cover.
2. Open the inner cover, holding it by its tab.
2
Load the stamp cartridge.
1. Remove the old stamp cartridge, using tweezers.
2. Push in the new stamp cartridge until it clicks, using
tweezers.
IMPORTANT
•
Make sure that the stamp cartridge is not protruding
from the surface.
•
Insert the stamp cartridge properly, or paper jams may
occur.
3
3
Close the covers.
1. Close the inner cover.
2. Close the feeder cover.
When closing the covers, be careful not to get your
fi ngers caught, as this may result in personal injury.
Routine Maintenance 49