How To Use - Remington BHT600 Bedienungsanleitung

ENGLISH
product and then to the mains. The charging indicator will light up.
Use product until the battery is low.
Your trimmer cannot be overcharged. However, if the product is not going to be used for an
extended period time (2-3 months), unplug it from the mains and store. Fully recharge your
body trimmer when you would like to use it again.
To preserve the life of your batteries, let them run out every six months then recharge for
14-16 hours.
EXCHANGING THE ATTACHMENTS
Always ensure the trimmer is switched off before changing the trimmer and shaver
attachments.
To remove, hold the Trimmer with one hand and turn the trimmer head anticlockwise with
the other.
To attach, hold the Trimmer with one hand and turn the trimmer head clockwise with the
other.
REVERSIBLE HEADS (Diagram A)
The attachment heads can be used in two directions. All the attachment heads can be
turned 180° in order to better reach all areas of the body:
ADJUSTING THE TRIM LENGTH
The guide comb for the trimmer attachment head can be adjusted to give you 9 different
trim lengths simply by moving the hair length selector on the comb to the desired setting.
The different settings represent 4mm to 12mm.
The guide comb for the body hair trimmer can be adjusted in 3 different settings by easily
sliding it onto one of the three slots on the attachment head. The different slots represent
3mm, 6mm & 10mm hair lengths.
NOTE: Trimmer comb must be attached to the product in order to use the hair length
selector.
USING THE TRIMMER HEAD (Diagram B)
Set the trimmer comb to the desired length setting. If you are trimming for the first time
start with the maximum trimming length setting
Turn the unit on.
Place the flat top of the trimmer comb against the skin.
Slowly slide the trimmer through the hair, in the direction of hair growth.
If hair builds up in the trimmer comb during the trimming process, switch the unit off, pull
off the adjustable trimmer comb. Brush trimmer/rinse comb.
For a closer and precise shaping, remove the adjustable trimmer comb and trim the hairs
along the outer edge.
EDGING AND SHAPING (Diagram C)
2
080781_REM_IFU_BHT600_22L.indd GB_2 080781_REM_IFU_BHT600_22L.indd GB_2

HOW TO USE

05.11.2008 18:02:39 Uhr 05.11.2008 18:02:39 Uhr