After Each Use - Remington HC5150 Bedienungsanleitung

ENGLISH
, STEP 3 – Side of the head
• With the comb set at 3mm or 6mm, trim sideburns. Then change to the longer
9mm guide comb and continue to cut the top of the head.
, STEP 4 – Top of the head
• Use the longer length comb attachment and set it to 24mm or 27mm then cut
hair on top of the head against the direction in which the hair normally grows.
• For longer hair on top, use the longer length comb attachment (24 – 42mm) to
achieve the desired style.
• Always work from the back of the head.
, STEP 5 – The finishing touches
• Use the clipper without an attachment comb for close trimming around the
base and sides of the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper. Place
the reversed clipper at right angles to the head, tips of the blades lightly
touching the skin and then work downwards.
, SHORT TAPERED STYLES – "FLAT TOPS" & SHORT CUTS
• Starting with the longest guide comb attached (24-42mm), cut from the back
of the neck to the crown. Hold the guide comb flat against the head and
slowly move the clipper through the hair.
• Use the same procedure from the lower side to the upper side of the head.
Then cut the hair against the direction in which it grows and level with the
sides.
• To give a "flat top" look, the hair on top of the head must be cut over the top
of a flat comb.
• Use a closer guide comb to taper the hair down to the neckline as desired.
C CARE FOR YOUR HAIRCLIPPER
• Your clipper is fitted with high quality blades.
• To ensure long lasting performance of your clipper, clean the blades and unit
regularly.
• Always keep the attachment guide comb on the trimmer blade.

, AFTER EACH USE

• Ensure the appliance is switched off and unplugged from the mains before
cleaning.
• Brush the accumulated hair from the blades. Do not submerge the clipper in
water.
• To clean the unit, wipe with a damp cloth and dry immediately.
6