Mounting - MC Crypt Hexagon Interior Bedienungsanleitung

Initial operation

Mounting

The assembly and the installation of the device must be carried out by a specialist who is
familiar with the hazards and the relevant regulations. Repairs, operation and maintenance of
the product may only be carried out by qualified personnel.
When choosing a location for your device, make sure to avoid vibration, dust, hot and cold
temperatures and dampness. Furthermore, no powerful transformers or motors must be set up
in the vicinity of the device.
The device must be mounted out of normal reach.
Illuminated objects must be at least 1 m away from the device's light emission. Easily-
flammable materials such as decorative fabrics must have at least a distance of 0.5m to the
device. Otherwise such objects might catch fire!
When mounting the product make sure that the power cord is neither jammed nor damaged by
sharp edges.
During installation and service work, the area underneath the place of installation must be
cordoned off.
The installation surface or mounting fixture needs to be designed in a way, that it can take 10
times its load capacity for at least 1 hour without damaging deformation.
It is also essential that the device is secured by means of a second safety restraint that is
independent of the actual mounting supports. If the main supports fail, no part of the
installation should be able to fall down.
During mounting, all the relevant regulations ( in particular BGV C1, in former times VGB 70 and
EN 60598-2-17) must be observed.
Acceptance test (by industrial use):
Before first use and after any significant modifications, the installation (including the electrical
connections) must be checked by a specialist.
A yearly check by a technical expert is necessary.
At least every four years, a quality inspection must be carried out by a technical expert.
• Install the effect beamer using a mounting bracket (1) on the ceiling, the wall or on a suitable crossbeam.
• Secure the device with fastenings that are compatible with the fastening surface and suitable for carrying the
weight of the light effect device.
• Secure the installation with an additional suitable safety restraint cable or net. The safety restraint cable or net
must be able to support the light effect device in the event of a fault in the main support system.
• Set the desired angle of inclination and tighten the bracket locking screws well.
17