X-lite X-501 Sicherheit Und Gebrauchsanleitung Seite 8

INSTRUCTIONS FOR USE
When riding on the road, the peak has to be adjusted to the highest position (see
Position 1 in fig. 1).
1 Adjustment
1.1 Unblock latches A and B by unscrewing them in an anticlockwise direction, as shown
in Fig. 2.
1.2 Rotate the peak on the side latches B to find the desired position which is the highest
one when riding on the road (see Position 1 in Fig. 1).
1.3 Block the peak in the position required by tightening latches A and B in a clockwise
direction (Fig. 2).
2 Disassembly
Completely unscrew latches A and B in an anticlockwise direction - as shown in Fig. 2 - to
completely remove the peak from the helmet shell.
3 Assembly
3.1 Place the peak on the shell making sure that latches A and B are inserted in the
corresponding slots.
3.2 Lock latches B by tightening them in a clockwise direction, until they return to their
original position (Fig. 2).
3.3 Adjust the peak as described in step 1.
• RACING COMFORT - INNER COMFORT PADDING
1 Disassembly of the cheek pads
1.1 Take hold of the RH cheek pad and pull towards the inside of the helmet to undo the
fastening buttons. (Fig. 3 - A).
1.2 Pull out the side flap from the shell sealing edge and detach all of the cheek pad from
the helmet. (Fig. 3 B).
1.3 Repeat operations 1.1 and 1.2 on the LH cheek pad
N.B.: the polystyrene frame the cheek pad is fastened to with buttons cannot be
removed.
2 Liner removal
2.1 Grasp the central area of the back rest and pull it towards the inside of the helmet in
order to slide out the central flaps located between the polystyrene and the shell.
Then, unhook the LH and RH side flaps from their fastening seats (Fig.4 A and B).
2.2 Grasp the central area of the liner and pull it towards the inside of the helmet in order
to slide out the central flaps located between the polystyrene and the shell, then
unhook the LH and RH side flaps from their fastening seats (Fig.5 A and B ).
2.3 Completely remove the liner from the helmet.
- 8 -