Safety Information - Oase ProMax ClearDrain 7000 Gebrauchsanleitung

• Operation under observance of the
technical data.
Possible incorrect use
The following restrictions apply to the unit:
• Not suitable for salt water.
• Not suitable for drinking water.
• Never use for pumping dirty wa-
ter/waste water.
• Do not use for long-term operation (e.g.
continuous recirculation of the water in
a pond).
• Do not use for commercial or industrial
purposes.
• Do not use in conjunction with chemi-
cals, foodstuff, easily flammable or ex-
plosive substances.
• Do not connect to the drinking water
supply.

SAFETY INFORMATION

This unit can be used by chil-
dren aged 8 and above and by
persons with reduced physical,
sensory or mental capabilities
or lack of experience and
knowledge if they are super-
vised or have been instructed
on how to use the unit in a safe
way and they understand the
hazards involved.
Do not allow children to play
with the unit.
Only allow children to carry out
cleaning and user maintenance
under supervision.
Electrical connection
• Only connect the unit if the electrical
data of the unit and the power supply
12
coincide. The unit data is to be found on
the unit type plate, on the packaging or
in this manual.
• Ensure that the unit is fused for a rated
fault current of max. 30 mA by means of
a fault current protection device.
• Extension cables and power distributors
(e.g. outlet strips) must be suitable for
outdoor use (splash-proof).
• Protect the plug connections from mois-
ture.
• Only plug the unit into a correctly fitted
socket.
Safe operation
• Dangerous electrical voltage. Possible
death or severe injury from electrocu-
tion! Before reaching into the water, al-
ways switch off and disconnect (isolate)
all units located in the water with a volt-
age of >12 V AC or >30 V DC and se-
cure them from being switched on
again.
• Only operate the unit if no persons are
in the water.
• Never operate the unit if either the elec-
trical cables or the housing are defec-
tive!
• Do not carry or pull the unit by its elec-
trical cable.
• Route cables/hoses such that they are
protected from damage and do not pre-
sent a tripping hazard.
• Only open the unit housing or its at-
tendant components, when this is ex-
plicitly required in the operating instruc-
tions.
• Only carry out work on the unit that is
described in this manual. If problems
cannot be overcome, please contact an
authorised customer service point or,
when in doubt, the manufacturer.
• Only use original spare parts and acces-
sories for the unit.
• Never carry out technical modifications
to the unit.
ProMax ClearDrain 7000/11000/14000