Before Start-Up - Phoenix Contact MCR-S-1-5-UI-DCI Betriebsanleitung

Current transducers MCR-S-...-DCI
Threshold value switch LED
Potentiometer for
threshold value
suppression time
Programming
interface
Upper part of
housing slides
open for DIP switch
setting
MCR-S-1-5-UI-SW-DCI
1)
Only for MCR-S-...-SW-DCI(-NC) versions.

1. Before start-up

• When operating the electric measuring transducer, certain parts of the module can
carry dangerous voltage. Ignoring the warnings can lead to serious injury and/or cause
damage.
• The MCR-S-...DCI modules should only be installed and put into operation by qualified
staff. The staff must have studied the warnings in these operating instructions
thoroughly.
• Safe and trouble-free operation of this device can only be guaranteed if transport,
storage and installation are carried out correctly and operation and maintenance are
carried out with care.
• The measuring transducer may not be put into operation if the housing is open.
• Qualified staff as described in these operating instructions means those persons
referred to as electricians or with an electro-technical training as defined in VDE 0105
Part 1/DIN EN 50110-1.
16
Power LED (green)
1)
(yellow)
1)
N
N E
I O
A T
O B
P R
A P
ENGLISH
I
D C
W -
I - S 0
6 5
- U
1 - 5
1 4
S -
R - 2 8
M C
r . :
t . - N
A r
S
A L
O V
P R
A P
/
N
N E
I O
A T
O B
P R
A P
MCR-S-10-50-UI-SW-DCI
Threshold value potentiometer
SPAN potentiometer
ZERO potentiometer
I
D C
W -
I - S
3
- U
- 5 0 6 6
1 0
1 4
S -
2 8
R -
M C
r . :
t . - N
A r
S
A L
O V
Cable
P R
A P
/
feed-through
Metal latch for fixing
to the mounting rail
1)
Fig.1