Conrad 61 88 88 Bedienungsanleitung Seite 23

When drilling holes in the wall or screwing tight, ensure not to
damage any cables or lines.
Make sure to observe the stated connection value. This is 230
V/ACH, 50 Hz, max. 6A (resistive load only) or 2A motors.
The recommended mounting height is 1.50 metres.
To ensure proper installation, proceed as follows:
a) Installation:
• Take the main fuse out of your fuse box (in
the case of screw lockings/automats) or
switch off the main fuse before starting
with the installation.
• Set the "Temperature adjuster" (2) to +5°.
The knob marks the correct position with the
black dot (see ill. 1).
• Carefully lift the knob (e.g. with a screw-
driver) and pull it off towards the top (see
ill. 2).
22
Figure 1
Figure 2