Philips Marathon FC9200 Bedienungsanleitung Seite 7

- Never use the appliance without the motor protection filter. This damages the motor and
shortens the life of the appliance.
- Only use the Philips filter cylinder supplied with the appliance.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
preparing for use
hose
1 To connect the hose, push it firmly into the appliance ('click') (Fig. 2).
2 To disconnect the hose, press the release button and pull the hose out of the
appliance (Fig. 3).
telescopic tube
1 To connect the tube to the handgrip of the hose, press the spring-loaded lock button on the
handgrip and insert the handgrip into the tube. Fit the spring-loaded lock button into the
opening in the tube ('click') (Fig. 4).
2 To disconnect the tube from the handgrip, press the spring-loaded lock button and pull the
handgrip out of the tube.
Use the same method to connect and disconnect the nozzles.
 Adjust the tube to the length you find most comfortable during vacuum cleaning (Fig. 5).
tri-active nozzle
The Tri-Active nozzle is a multi-purpose nozzle for carpets and hard floors.
- The side brushes catch more dust and dirt at the sides of the nozzle and allow you to clean
better along furniture and other obstacles (Fig. 6).
- The opening at the front of the nozzle allows you to suck up larger particles (Fig. 7).
1 To clean hard floors, push the rocker switch on top of the nozzle with your foot (Fig. 8).
The brush strip for cleaning hard floors comes out of the housing. At the same time, the
,
wheel is lifted to prevent scratching and to increase manoeuvrability.
2 To clean carpets, push the rocker switch again (Fig. 9).
The brush strip disappears into the nozzle housing and the wheel is lowered automatically.
,
Crevice tool, small nozzle and small brush
1 Connect the crevice tool (1), the small nozzle (specific types only) (2) or the small brush (3)
directly to the handgrip or to the tube (Fig. 10).
accessory holder
1 Snap the accessory holder onto the handgrip (Fig. 11).
2 Snap two accessories into the accessory holder:
- Crevice tool and small nozzle (Fig. 12).
Note: Make sure the suction opening of the small nozzle points away from the holder.
- Crevice tool and small brush (Fig. 13).
Note: Make sure the suction opening of the small brush points towards the holder.
4222.0003.3089.4.indd 7
English
7
22-11-2007 10:29:11