Renkforce RF-DAB-CAR1 Bedienungsanleitung Seite 37

Menu settings
Full scan
TX Frequency
DRC
Language
System Reset
SW Version
Complete station scan in the DAB reception range.
Setting the transmission frequency for the FM transmitter.
Set the desired transmission frequency by turning the rotary control
MENU (4) and confirm the setting by pressing the rotary control
MENU (4). During normal operation, the set transmission frequency
is shown at the top center of the display (7). Select a transmission
frequency that is not already occupied by a radio station.
To be able to receive the sound of the car receiver via the car radio, set
the reception frequency on the car radio to the transmission frequency
set here. If you are transmitting sound through the audio output
AUX OUT (10), no adjustment is required here.
This function compresses playback of sound to make low sounds better
audible at a low volume or loud environment.
Settings
OFF > no compression
1/2 > light compression
1 > high compression
Setting the Menu Language
Resetting the system to the factory settings in the event of malfunctions.
Attention: all settings will be deleted.
Display of the software version
37