Sygonix 1437491 Bedienungsanleitung Seite 28

• Insert the name tag behind the bell button and push it back into the outdoor unit.
• Place the outdoor unit in the weather protection frame.
• Mark the mounting position on the wall through the four holes of the outdoor unit.
Choose the mounting height at the wall so that the camera is placed in the best height. This depends on the
local situation of the entrance area of your house. The opening angle of the camera lens is approx. 45°.
• Place the connection cable between the outdoor and indoor unit and to the door opener and the power supply.
The procedure for the wiring and the connection to the voltage/power supply and the indoor unit or the door
opener is described in chapter 9.
• After the connection has been made, the connection area on the rear of the outdoor unit
must be closed via the enclosed plastic cover; insert the rubber ring into the plastic cover
first. It is used as a seal.
Attach the plastic cover on the rear of the outdoor unit with four small screws.
• Attach the outdoor unit (with attached weather protection frame) to the wall with four
suitable screws and, if required, dowels.
• Push the aluminium cover onto the outdoor unit (first on top, then at the bottom).
Make sure that the bell button moves smoothly and is not caught.
• Fasten the aluminium cover with the screws removed earlier.
28