Installing The Outdoor Unit - Sygonix 1437491 Bedienungsanleitung

7. Installing the Outdoor Unit

The outdoor unit should be installed in an area protected from direct precipitation (e.g. under an awning
next to the entrance door), so that the visitor is standing right in front of it when he pushes the button and
speaks into the microphone.
When drilling or tightening screws, ensure that no wires or lines are damaged! This also applies when
placing the connection cables (voltage/power supply and door opener) and any masonry work that may be
needed for this.
The mounting height is according to the local situation (e.g. stair in front of the door, etc.); the opening angle of the
camera lens is approx. 45°.
The figure above shows the version with one bell button; the procedure for the version with two or three bell
buttons is, however, identical.
Proceed as follows:
• Take off the weather protection frame from the outdoor unit.
• Turn the two screws (5 + 7) out at the bottom of the outdoor unit.
• Take off the aluminium-cover (fold it a little way out; it can then be removed easily).
• Pull the transparent bell button out (depending on version of the outdoor unit 1, 2 or 3 bell buttons).
• Label the name tag with permanent marker; alternatively, you can make your own tag, e.g., with a laser printer.
27