Delivery scope
DSO-1022 with removable rubber holster
2 NiMH accumulator packs
Power pack unit with Euro mains cable
Safety measuring cable
2 fully insulated contact probes (1:1)
Software CD
Setting up the handheld oscilloscope
Please install the oscilloscope by means of the handle on the rear in such a way that you can easily
operate and read it. To arrest the handle, press it into the casing.
In order to adhere to the tolerance values in the technical data, the measuring device
must work in the stated operating temperature range.
General information
Explanation of symbols and signs
AC
alternating quantity
DC
direct quantity
COM
Reference potential (negative pole with DC measuring)
mV
millivolt (exp.-3)
V
Volt (unit of electric potential)
Hz
hertz (unit of frequency)
kHz
kilohertz (exp.3)
MHz
megahertz (exp.6)
Ω
Ohm (unit of electric resistance)
kΩ
Kilo Ohm (exp.3)
MΩ
Mega Ohm (exp.6)
nF
Nanofarad (unit of electric capacity, exp.-9)
μF
Microfarad (exp.-6)
dB
Decibel (unit of attenuation, here decibel per milliwatt (dBm))
18