E) Changing The Bell Tone; F) Changing Settings For The Colour Display; G) Activating/Deactivating Muting - Renkforce 1275881 Bedienungsanleitung

e) Changing the bell tone

The bell tone can be changed if the video door intercom system is in standby mode. It does not
work while talking to one of the outdoor units.
• Push the button "
• Use the button "
• Confirm the selected bell tone with the button "

f) Changing settings for the colour display

The setting menu can only be called if the colour display is showing an image. For this, e.g. push
the button "
• If the display of the indoor unit shows the camera image, push the button "H" (6), to call the setting menu.
• Use the button "H" (6) to switch between
"Brightness": Setting the brightness
"Contrast": Setting the contrast
"Color": Setting colour saturation
"Exit": Leaves the setting menu
The current selection is marked in colour in each case.
• If "Brightness", "Contrast" or "Color" is selected, you can change the settings with the buttons "S" (7)
or "F" (8).
If "Exit" is selected and you push the button "S" (7) or "F" (8), you will leave the setting menu.
The setting menu is also left automatically if no button is pushed for a few seconds.

g) Activating/deactivating muting

Activating/deactivating muting is only possible if the video door intercom system is in standby
mode. It does not work while talking to one of the outdoor units.
With muting active, the indoor unit will not play the bell tone. Muting can be used, e.g. at night,
when you do not want to be disturbed.
• Push the button "
A red LED flashes in the button "
• To deactivate muting again, push the button "
40
" (3) to play the current bell tone.
" (4) to select one of 4 different bell tones.
" (4).
" (5) to activate muting.
".
" (3).
" (5) again. The red LED goes out.