Using The Shoulder Strap - Pattfield PE-AHE 18 Li Originalbetriebsanleitung

5.6 Adjusting the additional handle (Fig. 15-16)
(a) Setting the tilt of the additional handle
Open (a) the lock (F). Set the desired tilt of the additional handle (9).
Close (b) the lock (F).
b) Shifting the additional handle
Open (a) the lock (H) and slide the additional handle (9) into the re-
quired position. Close (b) the lock (H).

5.7 Using the shoulder strap

Warning! Always use the shoulder strap when working with the
equipment. Switch off the equipment before you take off the shoulder
strap (risk of injury).
1. Hook the carabiner (Fig. 4/Item A) into the strap holder.
2. Slip the shoulder strap (Fig. 17/Item 8) over your shoulder.
3. Adjust the length of the shoulder strap so that the strap attach-
ment is at waist level (Fig. 17).
4. The shoulder strap is equipped with a buckle. Press the hooks
together (Fig. 18) if you need to put down the equipment quickly.
5. To change the strap position on the equipment, press together
the two metal loops (Fig. 4/Item L / M) and adjust the strap attach-
ment on the tube.
5.8 Adjusting the angle of the handle (Fig. 19)
Press the two safety lock-off s (5) and adjust the angle of the handle
(2) to any of 4 latching positions.
5.9 Adjusting the angle of the motor housing (Fig. 20)
Press the two safety lock-off s (14) and adjust the angle of the motor
housing (13a) to any of 7 latching positions.
Anl_PE_AHE_18_Li_Basic_SPK7.indb 361 Anl_PE_AHE_18_Li_Basic_SPK7.indb 361
- 361 -
GB
15.01.16 13:09 15.01.16 13:09