Pattfield PE-AHE 18 Li Originalbetriebsanleitung Seite 349

5. Do not throw battery packs into an open fi re. There is a risk of ex-
plosion!
6. Do not ignite the battery pack or expose it to fi re.
7. Do not exhaustively discharge batteries. Exhaustive dischar-
ge will damage the battery cells. The most common cause of
exhaustive discharge is lengthy storage or non-use of partly di-
scharged batteries. Stop working as soon as the performance of
the battery falls noticeably or the electronic protection system trig-
gers. Place the battery pack in storage only after it has been fully
charged.
8. Protect batteries and the tool from overloads. Overloads will
quickly result in overheating and cell damage inside the battery
housing without this overheating actually being apparent exter-
nally.
9. Avoid damage and shocks. Replace batteries which have been
dropped from a height of more than one meter or which have
been exposed to violent shocks without delay, even if the housing
of the battery pack appears to be undamaged. The battery cells
inside the battery may have suff ered serious damage. In this res-
pect, please also read the waste disposal information.
10. If the battery pack suff ers overloading and overheating, the inte-
grated protective cut-off will switch off the equipment for safety
reasons. Important. Do not press the ON/OFF switch any more if
the protective cut-off has actuated. This may damage the battery
pack.
11. Use only original battery packs. The use of other batteries may re-
sult in injuries, explosion and a fi re risk.
Information on chargers and the charging process
1. Please check the data marked on the rating plate of the battery
charger. Be sure to connect the battery charger to a power supply
with the voltage marked on the rating plate. Never connect it to a
diff erent mains voltage.
2. Protect the battery charger and its cable from damage and sharp
Anl_PE_AHE_18_Li_Basic_SPK7.indb 349 Anl_PE_AHE_18_Li_Basic_SPK7.indb 349
- 349 -
GB
15.01.16 13:09 15.01.16 13:09