Pattfield PE-AHE 18 Li Originalbetriebsanleitung Seite 368

compressed air or cleaning it with a brush. Do not use tools for
cleaning.
•
Clean the equipment as required with a damp cloth and, if neces-
sary, mild washing up liquid.
Replacing the saw chain and cutter rail
The cutter rail needs to be replaced if the guide groove of the cutter
rail is worn; Proceed as described in the section "Assembly of the cut-
ter rail and the saw chain".
Checking the automatic chain lubrication
You should check the operation of the automatic chain lubrication
system on a regular basis in order to guard against overheating and
the associated damage to the cutter rail and the saw chain. To do
this, point the tip of the cutter rail towards a smooth surface (board,
section of a cut tree) and allow the chainsaw to run. If an increasing
oil trace becomes evident during this process then the automatic
chain lubrication system is working properly. If no clear oil trace is
evident then please refer to the corresponding instructions in "Troub-
leshooting". If the information contained there still fails to remedy the
GB
situation then please contact our service department or another simi-
larly qualifi ed workshop.
Important! Do not actually touch the surface with the tip of the cutter
rail when performing this test. Keep a safe distance (approx. 20 cm).
Sharpening the saw chain
Eff ective working with the chainsaw is only possible if the saw chain
is in good condition and sharp. This also reduces the risk of kickback.
The saw chain can be re-sharpened by any dealer. Do not attempt to
sharpen the saw chain yourself unless you have the necessary spe-
cial tools and experience.
Anl_PE_AHE_18_Li_Basic_SPK7.indb 368 Anl_PE_AHE_18_Li_Basic_SPK7.indb 368
- 368 -
15.01.16 13:09 15.01.16 13:09