How To Use; How To Clean - Panasonic MJ-L600 Bedienungsanleitung

How to Use

Extracting
Preparations
1 Install parts on the motor housing and assemble the lid. (P. GB12-14)
2 Prepare ingredients. (P. GB15-17)
3 Place containers under the juice spout and pulp spout.
●
When using the frozen cone, placing the pulp container is not
necessary.
4 Plug in mains socket.
1
Press the "I"
(ON) button.
2
Feed ingredients into the
feeding tube slowly and
push them down by using
food pusher.
●
Feed ingredients little by little
approximately every 5 seconds.
●
When using more than one kind of
ingredients, feed them little by little
alternately.
●
Do not force to push ingredients into
the feeding tube.
●
In the case of jamming of ingredients
or idle running, press and hold the "R"
(REVERSE) button for several seconds
3
(P. GB11).
After extracting is completed,
press the "O" (OFF) button
and close the spout cap.
After use
●
Pull out the mains plug.
●
Use the tip of cleaning brush to remove the pulp from juice spout and pulp spout.
●
Remove parts and clean them. (P. GB19-20)
Do not move the juicer by holding the lid or juicing bowl. (Dropping parts may cause injury.)
Note
●
Depending on ingredients (especially hard ingredients), their pulp may mix into the juice.
If pulp is disturbing your drink, strain your drink.
●
When pulp is not coming out or pulp is accumulating back of the pulp spout and top of the juice
attachment, turn the power switch off and remove them.
GB18
Food pusher
Feeding tube
Open the
spout cap
Pulp spout
Juice spout
Pulp container Juice container

How to Clean

●
Clean the appliance after every use.
●
Unplug before cleaning.
Do not use the following:
●
Do not use benzine, thinner, alcohol, bleach, polishing powder, metal brush or nylon brush, otherwise the
surfaces will be damaged.
●
Do not clean the appliance with a pointed object such as a toothpick or pin.
●
Do not wash the motor housing and juicing bowl in a dishwasher.
Food pusher / Lid
Wash with diluted dish soap (neutral)
and a soft sponge. Then rinse
thoroughly with water and dry well.
NOT dishwasher safe
Squeezing screw
Wash with diluted dish soap (neutral)
and a soft sponge. Then rinse
thoroughly with water and dry well.
• Use the cleaning
brush to clean the
bottom surface of
squeezing screw. Juice cone
(Black)
Dishwasher safe
Juice cone / Smoothie cone
Wash with diluted dish soap (neutral)
and a soft sponge. Then rinse
thoroughly with water and dry well.
• When the juice cone /
smoothie cone
is clogged, use
the cleaning
brush to clean.
Dishwasher safe
Motor housing
Wipe with a well-wrung cloth.
NOT dishwasher safe
Parts that can be washed in a dishwater
●
Before putting the parts into the dishwater, remove any residue on the parts.
●
High temperature may damage the parts. Always keep the parts away from any heat radiating devices
or lower the temperature of devices.
About discoloration of parts
Some discolouration of parts may occur
upon using ingredients like carrot or leaf
vegetable etc.
Cleaning all parts immediately after each
use will help to reduce stains.
Frozen cone
Wash with diluted dish soap (neutral)
and a soft sponge. Then rinse
Smoothie cone
thoroughly with water and dry well.
(Blue)
Dishwasher safe
Rotating brush (P. GB20)
Juicing bowl (P. GB20)
Accessories
Wash with diluted dish soap (neutral)
and a soft sponge. Then rinse
thoroughly with water and dry well.
Dishwasher safe
GB19