Connecting The Rain Sensor - FLORABEST FBC 7 A1 Bedienungsanleitung

Connecting the rain sensor

IMPORTANT
► A jumper
always be inserted if you are not connecting a rain sensor,
otherwise the programmed watering cannot take place.
► If the jumper is lost, you can bend a new jumper into shape
using standard commercial wire or a paperclip.
NOTICE
► An example of a compatible rain sensor is the Kärcher rain
sensor no. 2.645-037. You should also observe the operat-
ing instructions for the rain sensor.
► Please also note that structural changes to the rain sensor
connecting plug will result in the loss of warranty.
♦ Push the two levers for unlocking the terminals
remove the jumper
♦ Insert the cable ends of the rain sensor into the terminals
and then clamp them fi rmly by pushing the two levers back
down again.
FBC 7 A1
7 is inserted in the terminals
.
7
8 on delivery. It must
8 upwards and
GB
IE
8
11