Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Standard scope of supply
• Transport Case
• Coolant Unit
• Coolant Spray
• Chip Remover
• HSS Co Core Cutter Ø 22 mm
Switching on and off
• Check connecting line and plug on damages first.
• Push button MAGNET ON, in order to initiate the magnet and the magnetic adhesion is guaranteed.
• For non-magnetizable materials, please use the ROTABEST Vacubest (Prod.-No. 18150).
• When working on walls and ceilings, secure the machine with the safety belt.
For these operations we recommend cooling with our spray ALFRA BIO 4000, Prod.-No. 21040.
• Push the button MOTOR ON to start the Motor.
• To switch off machine proceed in reverse order: MOTOR OFF and then MAGNET OFF.
How to work with annular cutters
• Push ejector pin (center pin) through head of annular cutter.
• Core drills with Weldon shank are tightened with clamping screws (DIN 913) on both clamping surfaces.
• First place annular cutter with ejector pin on a marked center or marking.
• Spot-drill until the entire cut edge is formed as a circle.
Drilling with ALFRA ROTABEST cutters does not require much expenditure of force.
• During the drilling process the cutter should be cooled permanently. Optimal Cooling is possible by
internal cooling with our coolant unit.
• Do not stop the motor during the drilling process. After the process draw the cutter back with running
motor.
• Drill Chuck
• Safety Belt
• Ejector Pin
• Allen Key 2,5 mm
• Allen Key 6,0 mm
13
Werbung
