Stiga 102 M Bedienungsanleitung Seite 20

GB
SYMBOLS
The following symbols are displayed on the ma-
chine in order to remind you about the safety pre-
cautions and attention necessary when using the
machine.
The symbols mean:
Warning!
Read the instruction book and safety man-
ual before using the machine.
Warning!
Do not put hands or feet under the mower
deck casing when the machine is running.
Warning!
Beware of objects being flung out. Keep
spectators away.
Warning!
Before starting any repair work, remove the
spark plug cable from the spark plug.
ASSEMBLY - BASE MACHINE
Supplied with the mower deck is a plastic bag con-
taining assembly components (see fig 1 and 3):
Install the mower deck brackets on the base ma-
chine:
1. Place a washer C on the front wheel stub axle
(fig 4).
2. Then fit a mower deck bracket D (fig 5).
3. Place a second washer C on the outside of the
bracket.
4. Secure in position with a split pin B.
Repeat on the other side of the machine.
The mower deck brackets both have grease nipples
(see fig 5).
Lubricate these after every 25 hours' service (or at
least once a season) using universal grease.
20
ENGLISH
ASSEMBLY - MOWER DECK
MOWER DECK STOPS
Bolt both mower deck stops V onto the deck using
the bolts X and nuts Y (fig 6).
SUPPORT ROLLERS
Fit the four support rollers M onto the mower deck
frame (fig 2).
The rear support rollers should normally be placed
in the centre hole.
SUPPORT ARMS
1. Bolt the support arms R securely onto the mower
deck frame by means of the bolts S and lock nuts U
(fig 2). Do not tighten too hard. It should be possible
to move the support arms up and down.
2. Secure the support arms at the rear by means of
the pins J.
3. Fit the mower deck into the machine's mower
deck brackets D with the help of the screws S and
the nuts T (fig 7).
4. Hook the mower deck's lifting spring E into the
attachment lift (fig 7).
V - BELT
1. Set the height adjusting lever to position "5".
2. Remove the transmission cover.
3. Fit the v-belt over the mower deck pulley (fig 8).
4. Check that the tension roller F is resting on the
outside of the v-belt (fig 9).
5. Hook the end of the spring onto bracket G
(fig 9 - 10).
SETTING
For the attachment to mow evenly and cleanly it
needs to be adjusted correctly:
1. Make sure the tyre pressure is correct:
Front: 0,4 bar (6 psi).
Rear: 1,2 bar (18 psi).
2. Place the machine on a flat surface. Loosen the
screws I (fig 10).
3. Adjust the mower deck so that the rear end of
the casing is 10 mm higher than the front on
both sides.