Starting Operation; Installation - EuroLite N-10 Bedienungsanleitung

(5) Remote control-socket
(6) Fuseholder
(7) Power switch
(8) Power supply
(9) Attachment eyelet

STARTING OPERATION

Install the device on a plane surface.
The fluid tank of the device needs to be filled with smoke fluid before starting up operation and always
disconnected from the mains as fluid could be spilled.
Only use quality smoke fluids available at your dealer. We recommend high-quality Eurolite smoke fluids (e.
g. Eurolite Smoke Fluid "P" professional, 5 l). You must not use substances that are classified as "dangerous
working material" or "inflammable fluids".
If fluid should get into the interior of the device, disconnect from mains immediately and consult a technician.

Installation

Install the device in a well-ventilated area. The operation in an unsufficiently ventilated room can lead to a
condensation of the smoke fluid. The resulting slippery surface can cause accidents. Keep a minimum
distance of 20 cm around and above the device.
Furthermore do not orientate the escape nozzle directly in the direction of the audience's eyes. In order to
create a good effect, there should be a distance between the device and the audience of at least 1.5 m.
Only install the smoke-machine on fire-resistant, scratch-resistant and water-resistant surfaces.
Please make sure that the inclination angle does not exceed 15°.
This device is constructed for a standing or hanging installation. If the device is to be installed overhead, the
following safety instructions are binding:
Please consider the
installation! The installation must only be carried out by an authorized dealer!
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
5
6
7
8
DANGER TO LIFE!
EN 60335-1:1996 a nd the respective national norms during the
13/16
Fluid level:
Maximum
Remote
Control
Fuse: F 5 A, 250 V Type: N-10
Power supply: 230 V AC, 50 Hz ~
Power consumption: 500 W
Fuse: F 5 A, 250 V
ON
Power supply:
Minimum
230 V AC, 50 Hz
Year of construction: 2011
OFF
00061249.DOC, Version 4.0
Safety rope
MADE IN CHINA
www.eurolite.de