Switching On/Off - Cocraft NLT04 Original Bedienungsanleitung

Operating instructions
Batteries
1. Remove the battery cover and
insert 2 × AAA/LR03 batteries.
Refer to the markings in the battery
compartment to ensure correct
polarity.
2. Refit the battery cover.

Switching on/off

Switch the distance meter on by holding in [
Hold in [ ] again to turn the meter off.
Note: The laser switches off after 30 seconds and the meter switches off after
3 minutes of inactivity.
Clear/Undo
Press [ CLEAR ] to clear measurement results or backstep out of the selected function.
Selecting the measurement reference
Press [ ] (8) to switch the reference point between
the front (top edge) and rear (bottom edge) of
the instrument.
The default reference setting is the rear of the instrument.
Each time the meter is switched off the reference point
will be reset to the default setting (i.e. rear).
Selecting the unit for measuring distance
Press [ UNIT ] the required number of times to toggle between m, ft, in and ft+in.
Beep on/off
Press [ ] (6) to switch the beep signal on or off.
] (10) until the display illuminates.
7