Adjusting Parameters - LGB 10340 Betriebsanleitung

Operation
Place a train on the track between the stations. Adjust
the throttle to a medium setting. After a short pause,
the train will start and proceed to one station. When
it crosses the insulated track section, it will slow
to a stop. After the preset wait time has elapsed, it
will slowly accelerate in the opposite direction and
proceed to the other station. The train will shuttle
between the stations until the power is switched off.
12
ADJUSTING PARAMETERS (BOTH MODES)
Adjusting the station stop time
Halt Verzögerung
Pause Delay
The duration of the station stop is set with the "Pau-
se" switch and the "Pause" adjustment knob on the
circuit board.
• Set the switch on the right to select the range of
time adjustment: "x1" short (approx. 2 seconds - 1.5
minutes) (factory pre-set) "x10" long (approx. 1 - 8
minutes)
• Turn the knob to adjust the time within those
ranges.
Hints:
• In mode 1 "Basic," the selected duration is the time
1 x1
2 x10