Adjusting The Machine; Mounting Accessories - Ferm FBJ-710 Originalbetriebsanleitung

GB

3. Adjusting the machine

Adjusting the cutting depth
Fig.B
• Move the motor base (15) as far as possible
backwards.
• Set the cutting depth by turning the cutting
depth adjustment knob (7).
• Move the motor base forwards and check if
the pin (A) will fall in the notch of the
adjustment knob.
The following table shows the relationship of the
markings on the adjustment knob to cutting depth,
thickness of material and associated biscuit
dowel.
Marking Thickness Biscuit
of material Dowel
0 8-12 mm
10 12-15 mm
20 > 15 mm
S -
D -
Max. -
Adjusting the cutting angle
Fig. C
• The cutting angle can be set by unlocking the
clamping lever (8) and put the angle stop (4)
in the required angle.
• Should the clamping lever be in the way when
working with the tool, then pull the clamping
lever out and fasten it in a different position
without changing the cutting angle.
Adjusting the height
Fig. D
• The correct height can be set by unlocking the
clamping lever (9) and turning the knob for the
height adjustment (10) to the desired height
with aid of the scale (11).
• The height must corresponds to half of the
material thickness of the working piece, the
groove for the biscuit dowel must always be in
the middle of the working piece.
• Should the clamping lever be in the way when
working with the tool, then pull the clamping
lever out and fasten it in a different position
without changing the height.
8
Cutting
depth in mm
No. 0 8.0
No. 10 10.0
No. 20 12.3
Simplex 13.0
Duplex 14.7
- 18.0

4. Mounting accessories

Prior to mounting an accessory always
unplug the tool.
Mounting the saw blade
Fig. E
• Loosen the allen screw (16) with the supplied
allen wrench and open the top of the base
plate
• Press the spindle lock and turn the spindle
(17) until it engages in the lock. Keep the
spindle lock pressed during this procedure.
• Remove the flange nut (18) from the spindle
using the wrench (19).
• Position the saw blade (20) on the flange (21).
• Be aware that the arrow on the sawblade
indicates the same direction as the arrow on
the inside of the housing.
• Place the flange nut (18) on the spindle (17)
and tighten it with the wrench.
• The flange nut has two sides. One for
sawblades with bore 20 mm and the otherside
for sawblades with bore 22 mm.
• Take care that the flange nut will be placed
with the correct side on the spindle.
• Release the spindle lock and check that the
spindle is unlocked by rotating it.
• Close the top of the base plate and fasten the
allen screw (16) with the supplied allen
wrench.
Make sure that the top of the base plate
is securely closed before operating the
machine.
Mounting the dust bag
Fig. A
For dust extraction the dust bag (14) can be used.
Insert the dust bag (14) into the vacuuming
connection (13). Empty the dust bag regularly so
that the vacuuming performance remains intact.
5. Operation
Never use the spindle lock while the
machine is working.
Switching on and off
• To switch the machine on slide the on/off
switch forwards.