Tips & Tricks - In The Ditch XD Dolly Gebrauchsanweisung

TM
Tips & Tricks
The Crunch Zone
A simple little tip when yo find yourself in the crunch zone. The crunch zone is anytime you are up against
an obstacle such that you cannot fully raise the dolly using the break-over bar. Here is how to get is
accomplished with any of the ITD dolly products.
To Get Out of the "Crunch Zone":
1. Fully load the dolly tire that has full access for the break-over bar.
2. Insert the break-over bar into the BACK SIDE of the receiver tube.
3. Re-engage the Cam-lock and pull the bar towards the frame to lock it into the stowed position. This will raise
the vehicle tire up just enough such that you can pull away from the wall.
4. Repeat steps 1 through 3 on other side of dolly.
5. Once away from the obstacle, re-install the break-over bar in the stowed wheel receiver.
6. Apply a small amount of pressure forward to allow disengage of cam-lock.
7. Load dolly as normal and attached tie downs.
Steps 1 -3
Load Dolly Tire you have access to
Steps 6-7
Load vehicle completely
VIDEO ONLINE
www.intheditch.com
Operations Manual
WATCH THE INSTRUCTIONAL VIDEO AT:
www.intheditch.com
Steps 5
Move vehicle away from obstacle
Steps 7
Secure with tie downs
29