In The Ditch XD Dolly Gebrauchsanweisung Seite 42

TM
Spindle assemblies are a high stress critical component of the dolly
assembly. It is recommended that only a professional quality weld shop
perform the required repairs. Repairs performed outside of an authorized
repair shop will void warranty.
1. Remove Old Spindle Assembly:
Use a die grinder with a cut off wheel to remove old spindle
assembly. Cut along black lines indicated in picture to the
left. Remove parts and clean area. Inspect pivot pin holes
for excessive wear or damage.
2. Tack Spindle Assembly:
For proper operation a space of 0.040" to 0.050" is recom-
mended between the arms of the spindle assembly and the
side plate of the dolly. Assemble spindle parts along with
spacer. Clamp entire parallel.
Note: Metal shim stock is recommended as a spacer, 4-5
standard business cards may also be substituted.
3. Tack and Test Assembly:
Tack the loose spindle leg to the end of the 5/8" pivot pin
and spindle. Remove Clamp and shims. Rotate assembly to
check for free and easy movement.
4. Finish Weld Assembly:
Finish weld spindle assembly according to diagram to left.
Operations Manual
WARNING
Tack Location
Tack Location
22
Cut
Shim Stock
Plug Weld