Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TM
DOLLY MAINTENANCE
Visual Inspection
Before each use, perform a thorough visual inspection of the unit and all accessories.
Inspect for:
• Evidence of physical damage such as cracking
• Bending
• Deformation of plates and welds
• Cranking or Flaking of paint
• Fraying or deterioration of tie-downs or their mechanical members
• Loose rivets or missing end caps from the Dolly Axles
• Confirm that the cam locks engage fully
If any of these conditions exist, contact ITD and remove the equipment from service immediately. Repair or replace the
necessary components with ITD certified parts.
Maintenance (Each Use)
Always perform regular maintenance of the Speed® Dolly and its parts. Prior to each use:
• Check the tire pressure to assure it is at the recommended pressure listed on the tire side wall.
• Inspect Tie-Downs for frays, kinks, and defects. Replace immediately if any damage exists.
• Inspect the Break-over Bar for deformation. Replace if necessary with a Break-over Bar from ITD.
Maintenance (3 Months)
• Check Lug Nuts on Dolly Wheels. Tighten to recommended 95 ft-lbs torque.
• Inspect wheel bearings.
• Under normal use inspect and repack the wheel bearings once every three months.
• Under severe use, repack monthly.
• Use wheel bearing grease - We recommend Valvoline Optimum Choice
Aluminum Wheel Care
ITD aluminum wheels are coated with a durable clear coat to allow for a long lasting finish, to clean simply use soap and
water. DO NOT use any abrasive polish or cleaner, doing so may lead to damage to the wheel
Tire Inspection
When performing maintenance, check Speed® Dolly tires for irregular tread wear on tire tread and sidewalls, cracking,
scrapes, bulges, cuts, foreign objects and debris. Remove any foreign objects or debris embedded in the tread to prevent
damage. Tires with excessive damage on the tread or sidewall(s) should be removed from service and replaced.
Operations Manual
19
Werbung
Kapitel
Inhaltsverzeichnis
