Grease Points - In The Ditch XD Dolly Gebrauchsanweisung

TM

Grease Points

All Speed® Dollies have been designed with low maintenance in mind. Two grease points are all that is required for all
moving mechanisms.
SLS™ Speed® Lube Spindle Grease Points
The SLS™ Speed® Dolly and SLS™ XD® Dolly have been designed with low maintenance in mind. The Speed® Lube™
Spindle allows bearing grease to enter the center of the spindle with a standard grease gun. It forces new bearing grease
into the spindle, pushing the old bearing grease forward, then exiting the spindle. This completely repacks the bearing
with new, clean bearing grease. First remove the rubber plug from the spindle dust cap. With a standard grease gun,
inject fresh bearing grease into the circe until old bearing grease is pushed out the exit hole. Wipe clean to remove old
bearing grease.
MAKE SURE THAT YOU USE WHEEL BEARING GREASE TO LUBRICATE THE
SLS™ SPEED® LUBE SPINDLE
Grease Exit
Hole
In The Ditch recommends using Valvoline Optimum Choice when lubricating Speed®
Dolly grease points
Operations Manual
WARNING
New Grease
Pumped In
Old Grease Forced Out
20
Grease Exit
Hole