Setting The Water Hardness; Using A Water Filter - Melitta Barista TS Bedienungsanleitung

Care and maintenance
ATTENTION
A water filter may be damaged if it is
screwed in during the descaling pro-
gramme.
Remove the water filter when the appli-
ƒ
ance requests you to do so (see Fig. 25,
page 60).
Place the water filter into a vessel filled
ƒ
with tap water during the descaling
programme.
The water filter can be reinserted and
ƒ
reused when the descaling programme
is complete.
Requirement: The ready symbol appears
on the display.
1. Press the "menu/ok" button for 2 sec-
onds.
» The menu appears on the display.
2. Navigate to the Care > Descaling menu.
3. Use the arrow buttons to select Start
and confirm with "menu/ok".
4. Follow the further instructions on the
display up to the end of the descaling
programme.
» The ready symbol appears on the
display.

9.8 Setting the water hardness

The set water hardness influences the fre-
quency of descaling. The harder the water,
the more frequently the appliance has to
be descaled.
Information
The water hardness cannot be set if
you use a water filter (see section 9.9,
page 60).
Determine the water hardness with the
enclosed test strip. Observe the instruc-
tions on the test strip packaging and in the
table Water hardness range, page 62.
Requirement: The ready symbol appears
on the display.
1. Press the "menu/ok" button for 2 sec-
onds.
60
» The menu appears on the display.
2. Navigate to the Settings > Water hard-
ness menu.
3. Use the arrow buttons to select the
water hardness range and confirm with
"menu/ok".
4. Exit the menu with the Exit command.
» The ready symbol appears on the
display.

9.9 Using a water filter

The use of a water filter extends the ser-
vice life of the appliance and the appliance
has to be descaled less frequently. The
water filter contained in the scope of deliv-
ery filters calcium and other pollutants out
of the water.
46
47
1
48
Fig. 25: Screwing/unscrewing the water
filter
The water filter (47) is screwed into and
unscrewed from the thread (46) on the
base of the water tank (48) using the
screwing aid at the end of the enclosed
coffee spoon (1).
Inserting the water filter
Information
Place the water filter into a vessel filled
with fresh tap water for a few minutes
before inserting it.
Requirement: The ready symbol appears
on the display.