Parts Name; Technical Data - RUSTA 907511890101 Gebrauchsanweisung

USE
• Check that the voltage in the electrical outlet is the same as specified on the floor
fan's nameplate.
• Press down on the desired mode for speed setting: 0 (off), 1 slow, 2 (medium) or 3 (fast).
• Set the desired angle, tighten the nuts. Use the included wing nuts to help tighten the
nuts when setting the angle.
• Set the desired height.

PARTS NAME

ASSEMBLY
NOTE! All the pictures in this manual
Note: All the pictures in this manual are for
are for explanation purpose only.
explanation purpose only. Any discrepancy
Any discrepancy between the real ob-
between the real object and the illustration
ject and the illustration in the drawing
in the drawing shall be subject to the real
shall be subject to the real subject.
subject.
ASSEMBLY OF CROSS STAND & COLUMN UNIT
1. Loosen the butterfly screw and washer from the standing pole. Connect the
standing pole with the crossbase connector and fasten the butterfly screw with

TECHNICAL DATA

the washer.(Fig.1)
2.Attach 4 stands and slide into the crossbase connector. Ensure the stands are
Voltage
220-240V~50Hz
well fixed into the connector.(Fig.2)
Output 40 W
3.Loosen the height adjustment ring, lift the internal pole to the max height.(Fig.3)
You may adjust the extension tube to the desire height and then fasten the height
Front grill
Plastic nut
Front grill Plastic nut
Fan blade
Fan blade
Bakre skyddsgaller
Tighten
Tighten
Loosen
Loosen
Spinner
Spinner
Extension pole
Crossbase connector
Crossbase connector
Stand
Stand
Motor shaft
Motor shaft
Clutch knob
Clutch knob
Rear grill
Piano switch
Piano switch
Internal pole
Internal Pole
Extension Pole
Motor housing
Motor housing
Thumb screw Thumb screw
Fasten Fasten
Height adjusting
Height
ring
adjustment
ring
3