Hama RC 600 Bedienungsanleitung Seite 7

Alarm and SNOOZE function
When ALARM 1/ALARM 2 goes off, the corresponding alarm symbol
• Press the ALARM button (2) to switch off the alarm.
• If you press the SNOOZE/LIGHT (1) button, the alarm stops and the backlighting comes on for
5 seconds. The display for repeating the alarm (Zz) flashes. After 4 minutes, the alarm goes off again.
• If the alarm is not switched off, it stops automatically after 4 minutes.
5.7 Setting the time zone
• Press and hold the UP button for 3 seconds, the icon
• In the time zone and temperature display, hold down the MODE (5) button for
3 seconds. You can set the time zone (hours only) by pressing the
• Press the MODE buttonagain to confirm the setting of foreign time.
• Press and hold the
5.8 Setting the Dual Time
Press the MODE button (5) until DUAL TIME appears.
You can set a second time by holding down the MODE button (5) for 3 seconds in the DUAL TIME display.
• The hours display for the second time flashes and you can set it using the
• Press the MODE button (5) again. The minutes display for the second time flashes and you can set it using
the UP and buttons (3).
• Press the MODE button (5) again to confirm your settings.
5.9 Light on/off
When you press the SNOOZE/LIGHT (1) button, the backlighting is switched on and then switched off again
automatically after 5 seconds.
5.10 Motion sensor (integrated into the SNOOZE/LIGHT button (1))
The ON/OFF switch (7) on the back of the device must be set to ON. If you move your hand directly in front of
the motion sensor and no more than 30 cm away from it, the display will light up for about 5 seconds.
5.11 Temperature function
Press °C/°F (4) to switch the temperature display between Celsius and Fahrenheit.
6. Care and Maintenance
Only clean this product with a slightly moist, lint-free cloth, and do not use aggressive cleaning agents. Make
sure that water does not get into the product.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper
installation/mounting, improper use of the product or from failure to observe the operating instructions and/
or safety notes.
6
button for 3 seconds to choose between local and foreign time display.
/
1 2
F
will turn on.
or (3) button
flashes.
and buttons (3).