Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. If not, try to remove the sensor from its location, and bring it closer to
control panel and activate the sensor. It is possible that the sensor is
installed too far from the control panel and it cannot establish a steady
communication with the control panel. If this is the case, please install the
sensor closer to the control panel.
4. Replace the battery of the sensor in that zone if the Control Panel does not
respond when the sensor is activated within short range.
If you have multiple sensors in a zone, you may test the function of each
sensor to identify which sensor is having problem.
Replace Battery
Two CR-2032 lithium batteries are used to operate the temperature sensor.
When the sensor is in low battery condition, the low battery LED indicator
will flash.
When you see the low battery indication, replace
the batteries following the procedures below:
1) Remove the screw on the back of the
temperature sensor as shown.
2) Rotate the battery compartment, the batteries
can be removed.
3) Place the new batteries into the compartment,
pay attention on the polarity, as indicated on the diagram.
4) Tighten the screw.
16
Registration and Safety Certification/General Information
This device bears the CE symbol as specified by the provisions of Directive R
& TTE (1999/5/EC).
Hama GmbH & Co. KG hereby declares that this device is in compliance with
the basic requirements and other relevant guidelines and regulations of the
1999/5/EC guideline. You will find the declaration of compliance and declaration
of conformity in the Internet at http://www.hama.com
17
Werbung
