Inhaltsverzeichnis
Werbung
TROUBLE SHOOTING
Problem
The Power Switch is in On-
position. The Pilot Light (13)
does not illuminate.
The humidifier produces
little or no mist.
Humidity condenses on
furniture, walls or floors.
White dust
CONDITION OF SALE
As a condition of sale, the purchaser assumes
responsibility for the proper use and care of this
appliance in accordance with these printed
instructions. The purchaser or user must judge
himself or herself when to use the appliance and
the length or use.
ENGLISH
Possible Cause
1. The plug is not plugged in.
2. There is no power at the
outlet.
1. No water in Tank (3).
2. The unit is not placed on a
firm, level surface.
3. The Water Tank (2) was
washed with a washing
liquid and not rinsed
thoroughly.
4. Mineral deposits on Water
Sensor (9) or Nebulizer
(10).
5. Blower not operating (10).
6. Cartridge (6) is clogged.
7. Nebulizer not functioning.
1. The relative humidity in the
room is too high.
1. The water hardness is too
high.
2. The Cartridge (6) is
exhausted.
NOTE: IF YOU EXPERIENCE A PROBLEM
WITH YOUR HUMIDIFIER PLEASE SEE
WARRANTY FOR INSTRUCTIONS. PLEASE
DO NOT ATTEMPT TO REPAIR THE
HUMIDIFIER YOURSELF. DOING SO WILL
VOID THE WARRANTY AND COULD
CAUSE DAMAGE OR PERSONAL INJURY.
Technical specifications are subject to change.
7
Solution
1. Plug the humidifier in.
2. Check the circuits and fuses
or ask a specialist.
1. Fill the Water Tank (3).
2. Place the humidifier on a
firm, level surface.
3. Empty the water tank (3)
and rinse thoroughly with
warm water.
4. Clean Water Sensor (9) and
Nebulizer (10).
5. Ensure water in Reservoir (7)
is adequate to immerse
Water Sensor (9).
6. Replace used Cartridge with
a new one (6).
7. Ask a specialist and follow
instructions in the warranty
manual.
1. Follow the "Operating
Instructions".
1. Follow instructions
under "Demineralization
Cartridge ACA- 817E" and
use the extra filter KF-520E.
2. Replace exhausted
Cartridge with a new one.
Werbung
Inhaltsverzeichnis
