Meaning Of The Leds - ZyXEL VMG8825 Schnellstartanleitung

Meaning of the LEDs

Power
green on Power supply present.
flashing Device is being initialized or
green reset to the factory settings.
red on Device error detected, e.g., er-
ror
during self-test.
flashing New firmware is being loaded.
red Please wait.
off Power supply not present
DSL
on Successfully connected to
DSL.
flashing DSL synchronization is in
quickly progress.
flashing DSL connection being esta-
blished
slowly or synchronization failed,
e.g., because the DSL cable is
not plugged in or DSL is not
available.
off DSL interface not activated,
e.g., WANoE connection de-
tected
or configured.
WAN (WAN over Ethernet)
on LAN4 is configured as WAN in-
terface.
LAN4 is configured as LAN-
aus
interface..
INET (Internet)
green on Internet connection success-
fully
established.
red on Internet connection setup
failed, e.g., due to incorrect
access credentials
off No DSL and no WANoE con-
nection, or the device is being
operated in modem mode.
30 | ©2017
TEL (telephone)
green on SIP registration successful.
red on At least one SIP registration
failed, e.g., due to incorrect SIP
data.
off Internet telephony not
enabled.
2.4G WLAN
green on Wi-Fi 2.4 GHz enabled.
flashing Wi-Fi being enabled or
green disabled, e.g., after pressing
the WLAN button.
yellow After you press the WPS but-
flashing ton, WPS stays active for 2 mi-
nutes.
yellow flashing
quickly WPS error occured.
off Wi-Fi 2.4 GHz is disabled
WPS is not active.
5G WLAN
green on Wi-Fi 5 GHz enabled.
flashing Wi-Fi being enabled or
green disabled, e.g., after pressing
the WLAN button.
yellow After you press the WPS but-
flashing ton, WPS stays active for 2 mi-
nutes.
yellow flashing
quickly WPS error occured.
off Wi-Fi 5 GHz is disabled
WPS is not active.
LAN1 - LAN4
on LAN-Connection (ETH) esta-
blished.
flashing Active data transfer.
off No device connected.
Info
off not in use.
EN EN