Restoring Factory Defaults; Firmware-Update - ZyXEL VMG8825 Schnellstartanleitung

Restoring factory defaults

The RESET button is located on the back of the unit above the Power button.
ATTENTION
Resetting interrupts all ongoing telephone calls and Internet connections. Con-
sequently, if you have customized any settings on your VMG8825, please save the
custom configuration via the user interface before resetting the device. You can
then reload the configuration into the device later.
To restore the factory settings, proceed as follows:
1. Press the RESET button for about 10 seconds until the Power LED flashes.
2. The Power LED lights up red for about 30 seconds and then turns green again.
After about 2 minutes, the VMG8825 will be operational again.
3. You will now need to set up the VMG8825 again as described in the „Initial
setup" section or reload your saved configuration.
Firmware update
If you want to update the software of your VMG8825, please download this first
from the support pages of Zyxel at:
Then connect the computer on which the new firmware file is located via LAM pr
WLAN with your VMG8825 and call up the page
ser.
Enter the password for access to the user interface and open the menu item
System/Firmware Update. Follow the instructions there to perform the update.
26 | ©2017
www.zyxel.de
zyxel.box via your Internet brow-
EN EN