H-tronic AL 600plus Bedienungsanleitung Seite 9

with the VDE regulations. You must ensure
that all vehicle power consumers, such as
e.g. ignition, radio, light, telephone, mobile
phone battery chargers etc. are switched off,
if the battery is charged in a built-in state.
The lead battery must be dismantled or
unclamped if necessary. It is possible that
the battery has a leakage current or that the
battery is still connected to a consumer, if
the battery charger does not indicate
„Finished" or „Fuli" after a lengthy charging
period.
Always observe the warning notes of the
battery and vehicle manufacturer before
charging.
First, connect the red terminal (+) to the
positive terminal of the battery and then the
black terminal to the negative pole (-) of the
battery. Caution! Never clamp con-nections
onto the vehicle body. The battery charger
works at an ambient temperaturę of -25 °C...
+ 45 °C. Please infer at which temperaturę
or with which charging parameters a lead
battery must be charged from the technical
specifica-tions of the lead
manufacturer. The device can
temperatures of up to 50°C during fuli load
operation.
6. For experienced users (Ctuick in-
troduction)
Operation of the device
Connection to 230 V mains: First connect the
battery charger with the 230 V electri-city
mains (socket). The green „Mains" LED
lights up.
Set battery voltage:
Set the slide switch to 2V, 6 V and/or 12V
depending on the battery you want to
charge.
Connecting to the battery: Connect the red
connecting terminal of the battery charger to
the positive terminal (+) of the battery and
the black terminal to the ne-gative pole (-) of
the battery. The battery can thereby remain
connected in the car/ motorcycle (see notę
N3).
Charging procedurę
The device starts the charging procedurę
automatically. The „Charging" LED indi-
cates this.
Finished
The battery charger switches the „Finished"
LED on (see notę N3) and goes into the
refresh modę, if all test criteria have been
fulfilled after charging and the battery has
been evaluated as „Good". The „Charging"
LED extinguishes simultane-ously and the
„Refresh" LED is displa-yed. The battery is
therefore charged and ready for use and
can be disconnected from the battery
charger. Finally, puli the mains cable out of
the so-cket. Always puli the pług and never
battery the cable!
reach
Checktheacid level in non-maintenance-free
lead batteries. Fili with distilled water if the
acid level is too Iow. Observe the battery
manufacturer's operating instruc-tions.
10. Detailed description of the charging
procedurę
The „Mains" LED lights up after connecting
to the electrical mains (230V/50Hz). The
device goes into the check modę after
setting of the battery type by means of the
slide switch and connecting a 2V 6 V or 12 V
lead battery (Acid, gel, AGM, EXIDE gel
battery). The „Error" LED as
9