Eco - Radson TEMPCO RF CONTROL Bedienungsanleitung

Designed to be used when people are occupying the room or
may soon be.
Select this mode using the "+ or -" buttons then press OK . The
temperature setpoint appears on the screen. To modifythis,
press the OK button again and the temperature fl ashes. Use
the "+ or -" butt on to adjust it then press OK to accept.
The ambient temperature appears for 10 seconds followed
again by the temperature setpoint. The temperaturerange can
be between 5.5°C and 30°C. A three-color visual behavior indi-
cator displays during adjustment to inform you which tempe-
rature ranges involve low, medium or high energy consumpti
on and allow you to save energy.
�� Green: Low consumption, temperature between 5.5°C and
19°C
�� Orange: Medium consumpti on, temperature between
19.5°C and 24°C
�� Red: High consumpti on, temperature between 24.5°C and
30°C
This visual indicator allows the user to be aware of the risk
of excessive energy consumpti on when setting the comfort
temperature.
The temperature you have set it to is the desired room tempe-
rature for this operating mode. You need to wait several hours
for the room temperature to become stable again.
Pressing the back button displays the ambient temperature in
the room for 10 seconds, the symbol also displays.
AUTO TEMPERATURE OPERATING MODE
Designed to be used when people require automatic and
independent radiator operation as follows:
�� Priority 1: If the radiator is connected, control is via the
cable: Commands sent by EDF as part of an off -peak
contract such as Tempo or other "6 level" energy manager,
the temperature is adjusted based on the comfort mode
temperature setpoint.
�� Priority 2: The program currently set on the E3 program
controller (sold separately) if the remote control is paired
with it.
�� Priority 3: A program previously selected in program
mode on the remote control (d1 to d9, U1 to U9).
You can at any time change the temperature setpoint in
your program by pressing the OK butt on. The temperature
then fl ashes on the screen. Change it using the "+ " and "-"
butt ons then press OK again to accept. In this case, you are
now in timer exemption and the symbol appears on the
screen. Pressing the butt on exits the exemption and re-
turns to the temperature setpoint for your program. If not,
the exemption exits automatically after 2 hours.
Pressing the back button displays the ambient temperature
in the room for 10 seconds, the symbol also displays.
ECO TEMPERATURE OPERATING MODE
Designed to be used when people are not occupying the
room or are unlikely to be.
Select this mode using the "+ or -" butt ons then press OK .
The temperature setpoint appears on the screen. To mo-
dify. this, press the OK butt on again and the temperature
flashes. Use the "+ or -" button to adjust it then press OK
to accept.
The ambient temperature appears for 10 seconds followed
again by the temperature setpoint. The temperature range
can be between 5.5°C and 19°C but always 0.5°C lower
than the comfort temperature.
The temperature you have set it to is the desired room
temperature for this operati ng mode. You need to wait
several hours for the room temperature to become stable
again.
Pressing the back butt on displays the ambient tempera-
ture in the room for 10 seconds, the symbol also displays.
EN
8