Starting The System; Receiver; Receiver Indicator Light Status; Confort - Radson TEMPCO RF CONTROL Bedienungsanleitung

STARTING THE SYSTEM

RECEIVER

Connect your appliance to the electricity supply. Press butt on «B» located on the receiver at the bottom of the appliance
to start the radiator. Indicator light «A» is illuminated and you will hear 2 short «beep» sounds. Pressing butt on «B» again
will turn off your radiator and produce a long «beep» sound. Indicator light «A» goes out, and no communication with the
remote control is possible.

Receiver indicator light status

Operating mode
Standby

Confort

Anti-frost
Confort -1°C (*)
Confort -2°C (*)
Pairing mode
Sensor fault or
Measured temp. > 35°C
(*): Commands sent by EDF as part of an off -peak contract such as Tempo or other «6 level» energy manager.
The RF receiver is fi tt ed with an independent regulati on system which saves status informati on (start/standby) and
temperature setpoints to its memory. Storage of the last received setpoint ensures the temperature is sti ll regulated even
if the transmitter is turned off or its batteries exhausted. Also note that during a power outage to the radiators, pairing
does not need to be reiniti alized.
Important: If your receiver is turned off , your radiator will not receive any commands from the remote control.
Eco
Slow flashing green
Double flashing green
Double slow flashing
Indicator status
Radiator paused
Off
Steady green
Flashing green
green
Flashing Orange
Flashing red
Indicator status
Radiator Heating up
Steady red
Flashing red-green
Slow flashing red-
green
Double flashing
redgreen
Double slow flashing
red-green
Flashing orange
--
EN
6