Remote Controller - Märklin 29309 Bedienungsanleitung

remote controller, they must be removed from the
controller before recharging them!
• Rechargeable batteries should be charged up
only under the supervision of adults. Make sure
that you pay attention to the instructions for
operating the recharger you are using.
• Inequality of battery types, or new and used
batteries can not be used together.
• Batteries with the correct polarity insert.
• Remove run down batteries from the remote
controller.
• Contacts should not be shorted.
• If you are not going to use the train for a longer
time, remove the batteries from the remote
controller.
• Put on protective gloves to remove run down
batteries.Then clean the battery holder and the
contacts with a dry cloth.
• Batteries should not be handled by children.
Children could put batteries in their mouth and
swallow them. If a battery should be swallowed
take your child immediately to a hospital emer-
gency room.
• See Section 12 about disposing of batteries.

6.2 Remote Controller

Unscrew the battery holder and lift up the cover
1
Insert two (2) type AAA/LR 03 batteries as
2
shown in the drawing
12
Install or change the batteries only in
pairs according to the markings!
Pay attention to the polarity!
Put the cover for the battery holder back in
3
place.
Screw the battery holder down into place.
6.3 Train
The built-in rechargeable battery must be charged
up before operating the train for the first time!
Make sure the train is turned off before char-
1
ging the battery.
Plug the mini USB plug on the recharging
2
cable included with the train into the mini
USB socket on the train.
The USB plug for the charging cable included
with this set may only be connected to a
charging device from Protection Class II
(example: from a cell phone charger), which
is provided with the following symbol: