Beper 90.123N Betriebsanleitung Seite 15

Electronic kitchen scale - Use instructions
TARE FUNCTION :
When total sum of all loads on scale is bigger than 4% of scale's max. weight
capacity (200 gr when capacity is 5000 gr)
LCD shows "---" ou "0g" each time ZERO is pressed.
"---" means not stable, please wait for a moment.
"0g" and meanwhile an icon "TARE" (T) on upper left corner of LCD mean TARE
FUNCTION is active.
Max. weight capacity is reduced by total weight of all loads.
By pressing ZERO you can see the total weight of all loads on the scale.
If you want to weigh more loads, just press ZERO to reset LCD reading to "0"
again.
AUTO SHUT OFF FIG. 7
Auto shut-off occurs if display shows "0" or shows the same weight reading for 2
minutes.
MANUAL SHUT OFF FIG. 8
To maximize battery life, always press on/off again to turn off the scale after using.
Note: when display shows "0" press on/off to turn off the scale.
When display shows weight reading, press on/off for 3 seconds to turn off the
scale.
WARNING INDICATORS FIG. 9
1.Replace new battery
2.Scale overload. Remove item to avoid damage. Max. weight capacity is indica-
ted on the scale.
POWER
1. Remove the scale from the packing.
2. Open the battery case.
3. Insert battery type CR2032 (3V) paying attention to polarity.
4. Close the battery case.
ATTENTION
Low battery become dangerous for the possible loss of very corrosive liquid. To
avoid any damage, replace the battery as soon as necessary.
If the scale is not used for a long period, it is recommended to remove battery
from the case, in order to avoid damages with the corrosive liquid into the scale.
EVERY DAMAGES CAUSED BY BATTERY LIQUID WILL VOID THE WAR-
RANTY.
15